Solutions to common problems with carving machines

Focus on multiple fields, fibre-optic laser cutters, carving machines, sculptors, carvings.

1325 carving machine, numerically controlled starter problem resolution

A number of clients have asked questions about the recurring problems of engraving machines. A technical information on the maintenance of carving machines has been compiled for the 1325 engraving machines in order to help their families.

We all know that mechanical equipment has been in use for a long time, and it inevitably presents small problems, some because of the machine's own equipment, and others because of the faulty operation of the operator. The speed machine below provides us with the usual problems and solutions of the carpentry engraving machine 1325!

1325 Carpentry carpentry

I: Error in engraving machines

Reasons for this problem:

1: Control of carcasses or failures

2: Driver failure

3: Step-by-step power failure

4: Static interference

5: Mada line failure

6: Data line failure

7: Wrong path.

8: Axis fractured or loosed

9: Processing too fast

10: Computer system problems or viruses

Two: There's a lot of sculpture.

2: Step-in power failure

3: Driver failure or current breakdown inconsistent with software settings

4;z-axis motor line failure

5: Main axis power failure

6: Frequency changer interference or error in data setting

7: static interference

8: Computer viruses or system problems

Three: Chaos.

1: Control card failure

2: Frequency changer interference

3: File path error

5: Software setup problem

6: Error with drive failure or current breakdown

7: Data line failure

8: Computers with viruses or system problems

IV: The engraving machine is not smooth

1: Main axis not vertical; need correction

2: The knife has problems

3: Control card problem

Five: The carving machine is not going back to mechanical origin.

Reason for this problem

One in the opposite direction.

2: Control card failure or relaxation

3: Limit switches or data lines failure

4: Driver failure

5: Step-by-step power failure

Six: What if the engraving machine carves a wider line?

Solutions:

1. Adjust the focal length of the focus tube

2. Correct current regulation

Seven: The engraving machine's computer signal cannot be transmitted

Causes:

1. Incorrect software parameter setting

2. Machines and computers are not online

Three, there's a problem with the computer.

The software transmission rate is not consistent with the carving machine's Porter rate.

1. Resetting parameters

2. Press Offline to turn off off the offline lights

3. Use another series

Reset Porter Rate

Eight: The carving machine sounds unusual.

There's a blockage in the way of the car and the track. Objects

2. De-tracked cars

3. Inappropriate coordinates of origin

4. The actual version of the document is too large

1. Remove the blockage.

Two, pick up the car.

3. Modify the coordinates of origin

4. Modification of documents

Nine: The carving machine is empty

Reasons for this problem:

1. Diversion of light

2. Laser power damage

3. Related circuit or circuit damage

4. Laser tube damage or ageing

5. Power gauge damage

Solutions

Reference Notes, Alteration of Light

2. Replacement of laser power

3. Replacement of circuits or circuits

4. Replacement of laser tubes

5. Replacement of current meters

Created:

2020-11-20

Browser:

Collection

Previous:

The last: